3d-robotics Pixhawk Autopilot Manual do Utilizador descarregar pdf (Página 4)

Connect the ground (-), power (+), and signal (S) wires to the RC

pins using the provided 3-wire servo cable.

For a Spektrum DSM, DSM2, or DSM-X Satellite RC receiver, connect to

the SPKT/DSM port.

CONNECT RADIO CONTROL

FOR PPM RC RECEIVERS AND FUTABA S.BUS RECEIVERS

FOR SPEKTRUM SATELLITE RECEIVERS

FOR PWM RECEIVERS

Purchase a PPM Encoder module to connect a PWM

RC receiver to Pixhawk at store.3dr.com.

LOAD SD CARD INTO PIXHAWK

If the SD card is not preloaded into Pixhawk, insert the micro-SD card into the slot at the

bottom end of the board.

For a complete list of RC systems compatible with Pixhawk, visit the APM wiki page here.

1 2 3 4 5 6 7 8 9 ... 13 14

Sem comentários

3d-robotics Pixhawk Autopilot Manual do Utilizador Página 4